Assembly, Deck Spindle, 2011 and earlier 609F-019A
$282.51Complete Deck Spindle for pre-2012 Country Clipper mowers.
Does not include pulley, blades, or leveling washers.
Showing 33–48 of 689 results
-
-
Assembly, Deck Spindle, 2012 and later 629FN-001A
$307.87Complete deck spindle for 2012 and later Country Clipper mowers.
-
Assembly, Deck Spindle, flat top 660-045A
$235.99Complete Fat-top Deck Spindle for pre-2012 Country Clipper mowers. Does not include pulley or blades. Note: Item 609F-019A, along with 2 of 629-237P will also work in place of this part.
-
Auto-Lock Repair Kit – H-2196
$93.74Auto-Lock Repair Kit. Used on Front Deck PTO Shaft Coupling. Note: There are three different possible couplers used. If your parts do not look exactly like these, this kit will NOT work on your shaft. There is a 25% restocking charge on this item. This item is a non-stocking part, and is not normally kept…
-
Autolite Xtreme Start Iridium Spark Plug XST3924
$5.24Autolite Xtreme Start Iridium enhanced Spark plugs offer more focused ignition, quicker starts, less required voltage over the life of the plug, and improved emissions, compared to standard plugs. Replaces: Champion RC12YC NGK BKR5ES, BKR5EY Fits Country Clipper mowers with the following engines (may fit others): B&S (Twin) 15.5, 18, and 18.5 hp ELS OHV…
-
Autolite Xtreme Start Iridium Spark Plug XST4265
$5.24Spark plug for some Country Clipper mowers with Kawasaki engines.
-
Axle Hub, four bolt H-2584
$97.954 bolt hub assembly kit, with nut.
Fits most hydrogear hydrostats, 1ZT, EZT, CIZTReplaces H-2569
-
Backup ring 663-074P
$4.76Steel backup ring. This ring goes between the bearing and the seal in the front pivoting axle.
-
-
-
Ball Joint Bushing H-1989
$4.97Ball Joint Bushing This part is used to adjust the sensitivity/ smoothness of the joystick.
-
-
-
Ball Joint, Rod End H-2349
$82.20Rod end ball joint. 1/2″ x 1 1/2″ male threaded, 1/2″ bore, 1/2-20 fine thread This item is a non-stocking part, and is not normally kept in stock, shipping may be delayed.
-
Bearing Cap 620-201P
$6.33Bearing Cap 1/2″ hole This cap goes over the Idler Pulley on the top side of the spindle to keep debris out of the bearing.
-
Bearing Cap for spindles 609-292P
$5.55Bearing Cap. The bearing cap covers the top deck bearing and goes underneath the pulley. It helps keep debris and water out of the spindle bearing.